Try booting something different on proxmox like an ubuntu live desktop, just to make sure networking is working there. Seems like haos can’t talk to the Internet.

No, the browser would still send YouTube.com as the host header. While yewtu.be could be configured to allow this to work, the TLS cert would not and the browser would get upset.

Also the alternator absolutely takes more power from the engine in proportion to how much energy it’s putting out.

deleted by creator

O

Jellyfin is very conveniently packaged in docker, so while it may seem daunting, I highly recommend at least trying that route.

Running an nfs mount, docker or not, should be perfectly fine. Jellyfin just uses normal storage so won’t care if it’s nfs. No real special considerations with proxmox either, especially without worrying about a dedicated GPU. Just spin up a Debian guest and go.

Fortunately that’s not how it works when you have all the access points controlled centrally, like with unifi. Yes there is limited frequency space, but this is much less of an issue on 5ghz. There will also only be one ssid, and handoff between access points is pretty seamless.

3-4 is probably overkill, but the attenuation situation sounded pretty dire. I run two in my house for redundancy mostly, just standard American stud and drywall construction.

If you have the ability to easily add wires, I would go with a system that allows you to wire everything together, rather than depending on a purely wifi mesh. Personally I’m running unifi ceiling mounted access points for this. They run on power over Ethernet, so you just need to get one cable to each. You can control them with their free software controller if you are into that, or something like their dream router.

Run 3-4 of those access points placed throughout the house and you’ll never have a weak signal again.

Why does this only work in Hondas? What about this cares about the car?

Sand, sand, and sand some more. When you think you are done sanding, sand some more.

If you have a free pcie 4x or higher slot, you can throw in a cheap card to adapt to m.2 nvme, like 12 bucks. I’m running one in my older hp desktop that doesn’t have m.2 and it’s been working great.

I have no way to test this with the equipment I have, but what about opnsense on an x86-64 box and throw an sfp+ pcie card in there. You could then in theory turn off auto negotiation and set it to 2.5g. Has anyone out there tried this?

I’ve been running opnsense with my CenturyLink 1g setup, though I’m still using their ont to convert to copper, and been very happy with it.

This is >!zombo!< X.com!

I’m pretty sure sensi thermostats, when controlled by home assistant, do what you want. I haven’t confirmed they don’t still try to phone home, but that could be dealt with by some firewall rules. Other thermostats that support homekit should also work.

I do almost exactly the same, except I have opnsense running on a cheap dual nic mini PC so I don’t have that dependency on my proxmox servers. The unifi stuff does need a controller, but they publish a free app that you can run instead of getting their hardware.

We had two of these that ended up sitting in my desk at work back around that time. They were sent to us free with hopes we would port our (shitty) android/iOS apps to it. One was a bit newer, but they both just felt shitty compared to the equivalent Nexus or iPhone of the time, so I never bothered trying to use it as a daily driver. I wasn’t even on the app dev team, no one else wanted them or cared at all. Was fun as a technical curiosity though.

We moved to promox, and never looking back. Thanks Broadcom.