Suggestions for accurate gridding:

If you have access to a 3d printer, you can print these gridding rulers, which have made my life way easier since I discovered them.

If you don’t have access to a 3d printer, you could cut a small scrap of aida in the same count as your working fabric and essentially create a ruler for yourself. You’d still have to manually count out and mark the ruler, but you’d only have to do it once. Then you can just transfer the lines to your working fabric each time you start a new project.

Note that there is some variance in sizing, stretchiness, and whatnot between fabrics though, even if they’re all the same count. So you may still want to do a quick double check against the ruler before gridding the entire fabric.

TL;DR: PG&E has asked the CPUC to approve a 22% rate hike that factors in inflation and costs to move powerlines underground in high wildfire risk areas. The CPUC countered with “only” (my emphasis) a 12% rate hike and a proposal to insulate above-ground powerlines instead. The CPUC is set to decide on Nov 2.

My opinion: PG&E can go fuck themselves, and the CPUC can go help them, as per usual. If either of these organizations actually gave a flying fuck about people instead of dollars, they would cut executives’ million-dollar salaries before asking for yet another rate hike. Fuck PG&E and the CPUC.