I wouldn’t worry about the value difference too much but more the consistency. If you need 75 degrees on the edge then keep dialing up the temp until you get it.

It’s most likely only going to affect large prints at the end of the day.

Your printer will measure the bed from a single location so moving your IR sensor will vary across the bed. If your using a custom firmware I’m sure you could set this as an offset assuming your IR thermometer is accurate ;)

Heat of the bed will be the warmest point and the periphery cooler (just like your body temp)

What’s the bigger opinion on this. Is MS pushing onPrem Exchange as rotten apple to encourage the shift to 365 or are they genuinely pushing this info out for Administration awareness?

I would assume at this point any Orgs using onPrem are needing the services and thus assume it’s for awareness?

This guy fibers!

Docker is a method of virtualization on an application level.

You host a container platform on your computer and this allows you to utilise containers.

Example of Containers are applications such as

Plex Sonarr Pihole

Each container is a ‘complete’ platform with all the dependencies included - your container platform supplies Disk/CPU/Ram and network for the Container to function.

Containers can be based on operating systems that are different to your computer.

Using containers mean you have a very easy way of trying an Application without installing to your native operating system.

Let us know if you have a NAS /PC /Server and we can tailor the answer further.