Testprint - remove - measure - testprint - remove - measure - testprint - sleep - coffee - testprint WHATISTHATNOISE.

We will be reviewing processes around here.

    • NickKnight@lemmy.worldEnglish
      13·
      1 year ago

      The piece probably left the build plate and stuck to the nozzle, got pushed in and melted. OP got lucky and it didn’t hit anything hard and cause his leveller to break.

  • Poringo@lemmy.zipEnglish
    4·
    1 year ago

    Reminds me when I did not fastened my glass bed, it crashed down from like a meter and a half. Good thing it only chipped a corner.

    • MissJinx@lemmy.worldEnglish
      4·
      1 year ago

      I put my glass bed on top of my magnetic bed and it’s stuck lol. It still works fine but I can never use the magnetic bed or take the glass off again. Noob things

      • Poringo@lemmy.zipEnglish
        1·
        1 year ago

        Is the glass bed magnetic too? How did it get stuck? Can’t you just pull it? Sorry I don’t quite understand xD

        • MissJinx@lemmy.worldEnglish
          2·
          1 year ago

          So it’s not the top part, it’s the bottom part of the magnetic bed.I just put the glass on top and used the binder clips that came with it to make it not move, but the bottom part of tbe magnetic table was still there so it kind of melted at the glass kkk

        • MissJinx@lemmy.worldEnglish
          1·
          1 year ago

          no, I’m afraid to break the glass! Since it works I just left it lol. My printer is shit anyways so I’ll probably buy a new one at some point, then I’ll try to remove it. By now this is the only one I have lol

  • ThePrivacyPolicy@lemmy.caEnglish
    3·
    1 year ago

    I snapped a probe of a bltouch from a forgotten print on the bed :( after that day I added a webcam into my octoprint setup!

    On the upside, went crtouch the second time around because if had a shorter metal probe.

    • Backhandedsmack@lemm.eeEnglish
      3·
      1 year ago

      I had the same happen to me! My knockoff bltouch got it’s probe snapped off in an unfortunate speghetti incident. I took it apart and replaced the plastic probe with a bamboo skewer that I cut and shaped to the dimensions of the probe. It’s been working flawlessly for 3 months now.

  • kewko@lemdro.idEnglish
    26·
    1 year ago

    Almost as if zeroing is a sensitive process that should be done slowly 🤔