A while back after it was announced I purchased the Q0 to test its use as a macro pad. As part of that I figured why not do some pictures and write a little review.
The Good:
- Quality packaging means it wont be damaged in shipping
- The included C to C cable is great, and a good length
- The included A to C adapter is useful to have!
- The Foam between the plate and PCB is good quality
- QMK/VIA support is essential and works well
- ALU is good quality and well machined
- lots of little quality details, like rubber pads between the base and top of the case to keep it from rattling or shifting around.
- USBC port is on a daughter board that is replaceable separate from the main PCB.
- Screw in stabs
The Meh:
- The encoder is soldered not socketed so you cant swap it with something else or replace it.
- The encoder feels like garbage to me, it has "scratchy drag" and a the tactile feedback extreme and each step feels like its locking into position.
- The screws holding the case together require an Alan key, while on the inside the USBC port is screwed to the case using Phillips.... Why why are there two different types of screws!
- PCB and Plate are screwed using Phillips as well.
- Masonite (maybe) paper is glued to the bottom of the PCB to prevent shorts, but is a PITA to separate.
The WTF:
- listing says it has case foam on the bottom, mine does not.
- gasket is way to soft for me, i would have preferred a much stiffer foam, so I will have to replace this.
Overall, its nice, if you dont have a num-pad and are looking for a very high end, high quality one with extra macro tools this is a great fit. If you like stiff springs/switches you probably wont like the Gasket.
Build: 8/10 Feel: 4/10 Features: 8/10 Value: 6 /10